BTW, none of the above suggestions are working if the ISO file is larger than 4 GB because of the limitation of FAT32 file system.Using Rufus you can easily make pendrive bootable for any operating system like windows 10, windows 8, windows 7, linux, MacOs. However, it is a premium software. It is a GUI app and does the job more easily. UUByte ISO Editor is a quite good alternative to make bootable Windows USB installer on Mac.
Make Bootable Pendrive From File In Windows 10 ISO FileFirst, you need to download the Windows 10 ISO file. Iso file and keep it in a memorable location.Download Windows 10 Disc Image. Again, like the first method, you will need a USB drive (with a capacity of 16GB as a minimum recommendation) and you will also need to download the. In that case, you don’t have to install HomeBrew and wimlib since you can copy the file to the USB stick normally.Method 3: Use UNetbootin on Mac UNetbootin is free to use and allows you to make a bootable USB drive for Windows 10 using your Mac.It’s still worth a shot, though.Note: You can’t use Boot Camp Assistant on Mac’s with Apple M1 chipsets.1. It comes with an option to create bootable Windows 10 USB drives on a few Mac models, but it usually ends up running into issues while formatting or copying files to the flash drive. Give the Boot Camp Assistant a Try FirstBefore you go ahead, you may want to give the Mac’s Boot Camp Assistant a try first. If you do have a copy lying around, feel free to use it. Office for mac suiteThen, uncheck the box next to Install Windows 10 or later version and select Continue.4. Check the box next to Create a Windows 10 or later install disk. Select Continue on the Introduction screen.3. After Terminal finishes copying all files, unmount the USB from the desktop or use the following command (replace with correct disk identifier) instead.You can now disconnect the USB drive and use it to boot into your PC. However, this method can take a lot of time (up to an hour) to complete.Sudo wimlib-imagex optimize install.wim –solidCp install.wim /Volumes/WINDOWS10/sources/install.wim9. Copy and paste the following command and press Enter.Alternatively, you can use the two commands below to compress and copy the install.wim file to the drive. Go to Finder > Applications and launch Terminal.2.
0 Comments
Leave a Reply. |
AuthorBeth ArchivesCategories |